top of page
Bosch/Dremel 10.8 & 12v Battery Tap

Bosch 10.8v & 12v Battery Tap. These were designed in clip onto the top of your battery. Each mount has a set of spade connectors (with wire leads 6") that align with the connectors on the battery.


Tested to fit BAT411 BAT411A BAT412 BAT412A BAT413 BAT413A BAT414

Also compatible with the Dremel 12V B812-01, B812-02, B812-03. 


** It is important to take note of your battery charge level. There is no intelligence to this setup and is possible to run the battery level to low. **


Mounts are printed in Black PLA+ material and will hold up strong in an indoor environment. Outside sun/heat can cause the material to soften so if you do mount in say a work van, proceed with caution. We do have alternative options that will hold up long term to outdoor use. Please message us before ordering for a quote for that


These are 3D printed in house and made to order. These take several hours to create so please factor in a day or two for order processing. Each print will also have our logo embossed.

Bosch/Dremel 10.8 & 12v Battery Tap

    bottom of page