3D Printed Dewalt 20v Car Jumper Harness. Each harness allows you to jump your vehicle when in a bind. The adapter does not lock onto the battery so will allow quick connect/disconnect. Wire is 2ft in length with alligator clips for terminal connection.
** It is important to take note of your battery charge level. There is no intelligence to this setup and is possible to run the battery level to low. The batteries are not designed for this use, so proceeded at your own caution. The potential of damaging your battery is present **
These are not meant to be a first grab tool, but a last ditch effort device. There is no logic in these adapters so risk of damage to your battery is present. Batteries can be replaced if they become a live saving item in a situation.
Battery is NOT included. Only the 3D printed adapter harness. Mounts are printed in Black ASA material and will hold up strong in an indoor and outdoor environment.
These are 3D printed in house and made to order. These take several hours to create so please factor in a day or two for order processing. Each print will also have our logo embossed.
top of page
bottom of page